示波器模块_光谱仪_衰减器_仪器仪表租赁_深圳市美佳特科技有限公司

咨詢熱線

18948178581

當前位置:首頁  >  產品展示  >  通用電子測量?jī)x器  >  測試測量  >  TESEQ NNB 51 雙線V型阻抗穩定網絡

TESEQ NNB 51 雙線V型阻抗穩定網絡

簡要描述:TESEQ NNB 51 雙線V型阻抗穩定網絡,雙線V型LISN符合CISPR 16-1-2的要求電流可達16A頻率范圍:9 kHz~30 MHz手動和遙控操作接地平穩

  • 產品型號:NNB 51 TESEQ
  • 廠商性質:經銷商
  • 更新時間:2024-08-18
  • 訪  問  量:832

詳細介紹

品牌其他品牌產地類別進口
應用領域電子

TESEQ NNB 51 雙線V型阻抗穩定網絡


雙線V型LISN符合CISPR 16-1-2的要求電流可達16A頻率范圍:9 kHz~30 MHz手動和遙控操作接地平穩


產品特點:應用:線性阻抗穩定網絡(LISN) NNB 51是用來測量電子設備在被測環境下電源線的失真信號。失真信號通常是被測件和電源線產生作為天線。歐洲和電磁兼容法規對大允許信號水平和頻段的信號失真做了規定。通過安裝NNB 51前面板上的N型同軸線纜可測量失真信號。測量接收機可以測量實際失真信號。V-network是復雜的EMC測試設置的一部分,CISPR 16-2-1 (EN 55016-2-1)中有明確規定。供電:在NNB設備的后部分別有兩個輸入接口鏈接被測件電源。接地:NNB 51的構造允許與屏蔽室墻壁大面積接觸。前面板的左右兩側是接地板。其他在LISN后部的是連接螺栓和螺釘。遠程控制連接:NNB 51內置兩個遠程控制線路,可以控制MEB/夏弗納SCHAFFNER/特測TESEQ或羅德與施瓦茨的EMC接收機。


技術參數:適用標準: CISPR 16-1-2, MIL-STD-461D, E頻率范圍: 9 kHz ~ 30 MHz負載 (內置): 10 dBNNB 工作電壓: 100 ~ 120 V / 220 ~ 240 V, 50 ~ 63 HzEUT 工作電壓: max. 250 VEUT 頻率: DC ~ 63 HzEUT 相位檢測功能(LED): >48 VEUT 工作電流: max. 16 A線性阻抗: 50 Ω || (50 μH + 5 Ω)額定輸出阻抗: 50 ΩRF 接頭: N 母頭模擬手 / 接頭: 510 Ω + 220 pF / 4 mm 香蕉插頭限幅器: 約136 dBμV typ., 可轉換模擬 PE: 可轉換雙線遙控插頭: KFV 60四線遙控插頭: D-sub 25 針尺寸(W x D x H) 不含安裝配件: 237 mm x 375 mm x 265 mm尺寸 (W x D x H): 270 mm x 418 mm x 275 mm重量: 約12 kg ApplicationLine impedance stabilization network (LISN) such as the NNB 51 are used to measure distortion signals on the mains cord of an electrical equipment under test (EUT). The distortion signals are usually generated or picked up inside of the EUT and the mains cord acts as an antenna. European and international EMC regulations define maximum permissible signal levels and frequency bands for such distortion signals. The distortion signal to be measured is available on a coaxial N?connector that is mounted on the front panel of the NNB 51. For the actual measurement of the distortion signals a measuring receiver can be used. The V?network is part of a complex EMC?test setup that also has been standardised in CISPR 16?2?1 (EN 55016?2?1).Power supplyThe NNB 51 has two separate input connectors for the mains power of EUT and NNB that are located on the rear of the instrument. Earth connectionThe construction of the NNB 51 allows a massive connection to the shielded room wall. Left and right of the front are grounding bars. Additional are located a connection bolt and wing screw on the rear of the LISN. Remote control connectionThe NNB 51 has two built?in remote control circuits and can be controlled with EMI receivers from MEB/Schaffner/Teseq or Rohde & Schwarz. Standards applied: CISPR 16?1?2, MIL?STD?461D and EFrequency range: 9 kHz to 30 MHzAttenuator (build?in): 10 dBNNB operating voltage: 100 to 120 V / 220 to 240 V, 50 to 63 HzEUT operating voltage: max. 250 VEUT frequency: DC to 63 HzEUT phase detection function (LED): >48 VEUT operating current: max. 16 ALine impedance: 50 ? || (50 μH + 5 ?)Nominal output impedance: 50 ?RF connector type: N femaleArtificial hand / connector type: 510 ? + 220 pF / 4 mm bananaLimiter: approx. 136 dBμV typ., switchableArtificial PE: switchableTechnical specifications, continuedConnector type for two wire remote control: KFV 60Connector type for four wire remote control: D?sub 25 pinsSize (W x D x H) without mounting parts: 237 mm x 375 mm x 265 mmSize (W x D x H): 270 mm x 418 mm x 275 mmWeight: approx. 12 kgPart number Description253550 NNB 51 Dual?line?V?LISN for 16 A97?253550 NNB 5x?TC Traceable calibration (ISO17025) order only with new device 232080 LE 216 Control cable SCR 35xx / NNB xx243134 LE 234 Control cable SMR 45xx / NNB xx


TESEQ NNB 51 雙線V型阻抗穩定網絡

深圳市美佳特科技有限公司(簡稱“美佳特")成立于2010年,致力于光通訊測試、通用電子測量及5G測試服務。美佳特以“無線溝通,溝通無極限 "企業使命,業務聚焦于精密測試測量?jī)x器的租賃、銷售、維護、計量及測試環境搭建等一站式服務。N2843A Keysight 無源探頭 Keysight 是德


主營產品:示波器主機和模塊、眼圖儀、光譜儀、信號源、頻譜分析儀、網絡分析儀、阻抗分析儀、光通信儀器、誤碼儀、光時域反射儀、可調諧激光源、光功率計、光衰減器等。合作品牌:安捷倫、是德、泰克、安立、愛得萬、安騰、力科、馬可尼(IFR)、R&S、EXFO等。N2843A Keysight 無源探頭 Keysight 是德


主推:Agilent 86100D/C 示波器,keysight M8195A 任意波形發生器,Anritsu MS9740B/A 光譜分析儀,YOKOGAWA AQ6370D/E 光譜分析儀,keysight N1092A/C 采樣示波器,keysight E8257D 模擬信號發生器,keysight E5071C 矢量網絡分析儀


產品咨詢

留言框

  • 產品:

  • 您的單位:

  • 您的姓名:

  • 聯系電話:

  • 常用郵箱:

  • 省份:

  • 詳細地址:

  • 補充說明:

  • 驗證碼:

    請輸入計算結果(填寫阿拉伯?dāng)?shù)字),如:三加四=7